With these Flexipads Denim Orange Peel Removal pads you can now remove or substantially reduce orange peel without sanding.
While removing orange peel and deep defects you are also polishing the paint rather than leaving sanding marks this reduces the subsequent steps required.
Suits the Flexipads 10400 backing pad
Remove Orange Peel and deep defects while simultaneously polishing paint.
Equivalent to approximately 2000 grit sanding medium without the dulling of paint and sanding haze.
Remove the Orange Peel effect without sanding and the haze created by sanding.
Breather perforations to avoid paint dust build-up on pad and help reduce the build up of heat.
Less dust and clean up prior to finishing polish.
Directions for use:
Attach to Hook & Loop backing plate on a Rotary polisher.
Apply a few drops of polish to paint or pad according to your skills and preference.
When in use these pads need to be used at a relatively low speed with a soft backing pad, with little to no pressure applied. Denim pads should not be allowed to dry out, a good amount of liquid compound should be used.
We also recommend refining the finish with a foam pad to develop an optimal polished finish"
Work a 2' x 2' section or larger to keep heat down as needed but remember the larger the area the more time it will take to level orange peel and defects.
Begin working polish on low speed for a pass or so.
Step up speed to approx. 1200 rpm (adjust as needed).
With proper lighting observe the level of orange peel removal while you work.
Apply more polish if needed or a spray of water on pad to re-activate lubricants.
When satisfied with orange peel and defect removal slow speed, ending at 600 rpm as you finish down the polish.
Size: 150mm (6") Diameter
Pore Size: 90ppi
Material: Denim Surface with Hook & Loop backing
Made in: Great Britain